How to ensure the stability of storage racks?

The stability of the storage rack, in fact, is essential to be done in the design stage. Instead of cutting corners in the design, rely on post-operation management to increase inspections (the practice of repairing a sheep after a dead sheep). What should be paid attention to in the design stage?

The anti-seismic level of the storage rack.

This indicator itself has relevant national and local regulations. Some companies will also increase the anti-seismic level on the basis of the regulations.

The weight of each pallet of goods.

Normally, the weight of each pallet on the storage rack does not exceed 1 ton. The greater the weight of each pallet of goods, the correspondingly larger (thicker) materials need to be used. such as beams and posts. So we should pay attention to the weight of each pallet of goods.

Quipped with anti-collision columns and guardrails.

For non-autonomous warehouses, there is a high probability that forklift drivers will be used to drive forklifts to complete the loading and unloading of goods. In this case, some protection must be provided for the columns of the racks. For example, for anti-collision columns and guardrails, such as drive-in racks, it is best to design guide rails on both sides of the first floor to prevent forklifts from hitting the post.

The load-bearing capacity of second-hand storage racks will be reduced.

If you are buying second-hand storage racks to save money, you must check them during installation to prevent deformed materials from mixing in. In addition, if the carrying capacity of the new storage racks is 1 ton, then when using second-hand storage racks to store goods, put each plate Cargo with a load of fewer than 0.8 tons.

After the installation of the storage racks is completed and put into use, the managers of the warehouse must also devote a certain amount of energy to the management of the storage racks.

For new goods entering the warehouse, when designing the stacking standard, in addition to paying attention to the height of the entire pallet of goods and not exceeding the height, we must also pay attention to the load and do not exceed the maximum carrying capacity of each pallet of goods on the storage rack.

For the anti-collision pillars, guardrails, etc. that are damaged due to human reasons, they must be repaired or replaced in time to avoid further damage.