Cantilever racking system


Proper installation of a cantilever rack is essential. This may make sure that the people using it, and the substances stored together with it, may never be at risk. Although it’s true that the installation is typically done by builders, having a fundamental understanding of cantilever racking is an excellent benefit. Having enough understanding allows you to conduct a thorough checkup especially when the builders are not able to satisfy your needs. Cantilever racking stands require sufficient space for assembly, therefore site preparation is crucial. A concrete substrate should be strong enough for support as the cantilever column will need a steady ground to defy holding heavy materials.

Aside from that, the floor condition has to be completely analyzed particularly when the storage location is predisposed towards changes in temperature. The ground condition is different throughout the rainy season as compared with dry weather. Conducting a ground survey is essential. If you’re planning to put a tall cantilever rack, ensure that it might withstand heavy winds and rains. The storage place should also have strong slabs and outdoor areas for support. Each of them should be under the permit requirements fixed by the local authorities. When all these factors are fine, then the cantilever racking is prepared to be installed.

Fundamentally, there are two stages in cantilever racking assembly. Those are the bracing and the anchoring. Each step has to be seriously completed to make sure its stability over time. Make sure that each part will be stable for a very long time. Bracing – Bracing is the process of installing columns, which ought to be established in 2 sections for stability. Most builders would install more than 2 columns, depending upon the requirements of the client. Bracing is carried out between every column – this is irrespective of the number of rows along with columns. Anchoring – anchoring is the actual setup of bases and columns.

Usually, this is done by using inches diameter of wedge anchors placed in a slab. It’s perfect to place 2 anchors per column along with 4 anchors at each base set up. In order to make sure that the cantilever rack won’t fall, the anchors ought to be embedded at least inches into the concrete slab. Fasteners are also important as the other parts as it prevents the rack from swaying. The foundations connected to the columns must have fasteners of about inches bolts or nuts.

In addition, the arms connected to the columns ought to be fixed by the same size of bolts or nuts. Each column attached might need about 4 fasteners. The bracing can be fastened to a column of the same size. It may take a couple of days before the whole setup is completed.